Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need a pic of arduino, Lenz shield, and lcd keypad shield.
#1
Hello Mr. Lenz and everyone here!
I am trying to follow instructions in documentation and I will be soon finished with the product. However, I was wondering if anyone could share pics of how the shield should look like assembled and soldered with resistors, optocouplers, pins for motor connectors, easydriver and etc. I just want to see if I am in right direction.
Thank you!
Reply
#2
(03-10-2015, 12:31 AM)wypyr Wrote: Hello Mr. Lenz and everyone here!
I am trying to follow instructions in documentation and I will be soon finished with the product. However, I was wondering if anyone could share pics of how the shield should look like assembled and soldered with resistors, optocouplers, pins for motor connectors, easydriver and etc. I just want to see if I am in right direction.
Thank you!

Seems like you never tried looking on my page especially for the miniEngine 1 Wink
http://www.minie.airiclenz.com/hardware-2/hardware/

/Airic
Reply
#3
(03-10-2015, 11:00 AM)Airic Lenz Wrote:
(03-10-2015, 12:31 AM)wypyr Wrote: Hello Mr. Lenz and everyone here!
I am trying to follow instructions in documentation and I will be soon finished with the product. However, I was wondering if anyone could share pics of how the shield should look like assembled and soldered with resistors, optocouplers, pins for motor connectors, easydriver and etc. I just want to see if I am in right direction.
Thank you!

Seems like you never tried looking on my page especially for the miniEngine 1 Wink
http://www.minie.airiclenz.com/hardware-2/hardware/

/Airic
Hehe, thanks! Big Grin 
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)