Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My First use
#1
Hey Eric,
thanks for opening a new forum section for your software.

So first of all thanks for the kind tip that we can use the programming port of the arduino to run and setup with the software.

My first test ran ok, so long if i programm the run at the pc and then push it into the MiniE, and start it from there. If i use the Software to start the run, or go back home the motors do strange things.
Perhaps it's only my system doing such things?
I'm running it on a Notebook with Windows 8.1 x64.

BUt now i am very lucky that i build my case with an external USB Port ;-)

greetz
Sascha
Reply
#2
(08-14-2014, 08:52 PM)Sascha Wrote: My first test ran ok, so long if i programm the run at the pc and then push it into the MiniE, and start it from there. If i use the Software to start the run, or go back home the motors do strange things.
Perhaps it's only my system doing such things?
I'm running it on a Notebook with Windows 8.1 x64.

Could you send me your setup so that I can try to replicate the strange behavior?

Thanks!
Reply
#3
(08-14-2014, 10:21 PM)Airic Lenz Wrote:
(08-14-2014, 08:52 PM)Sascha Wrote: My first test ran ok, so long if i programm the run at the pc and then push it into the MiniE, and start it from there. If i use the Software to start the run, or go back home the motors do strange things.
Perhaps it's only my system doing such things?
I'm running it on a Notebook with Windows 8.1 x64.

Could you send me your setup so that I can try to replicate the strange behavior?

Thanks!

Which files do you want to have??

Edit: The .mep files are not allowed
Reply
#4
(08-14-2014, 10:29 PM)Sascha Wrote: Which files do you want to have??
Edit: The .mep files are not allowed

Yes I meant the .mep (miniEngine path) file and they should now be allowed.
Thanks!
Reply
#5
Here it is Wink


Attached Files
.mep   miniEngineSetup.mep (Size: 3.55 KB / Downloads: 35)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)