Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repeat mode?
#1
Hello, I'm not sure if this is the right place for CineMoco feature requests?

Would it be possible to add a "repeat mode" - an alternative to bounce mode, where rather than reversing the program, the controller simply repeats the program based on its current location. ie, current position (end) would become the new start position, and end would = current position + previously specified # of motor steps. The goal being, I would like a move to repeat endlessly rather than bounce back and forth, so that I can setup long circular moves where I only have to specify a portion of the arc as the start/end, and then have it repeat. I might want to use this with ramp in/out, or without.

Thank you for your consideration.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)