Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Acrilyc Box V2
#1
Hello All

I tried to design acrylic box miniE engine V2 only $25 us

Thx
Ed

               

original skema .ai
Reply
#2
Is possible to buy one unit?
Reply
#3
(06-01-2014, 10:26 AM)arian Wrote: Is possible to buy one unit?

Hi Arian ...

I tried to design Minie V2 box is not for sale, but to be shared for all here.

if not perfect let's fix.

regards
ed
Reply
#4
Nice work Ed!

Can you share the design files so that everyone can order its case? If there is a problem attaching your files, I can fix that - just let me know!

Thank you!
Reply
#5
Hi Airic

After ready all, later I will share all that is here.

thanks,
ed
Reply
#6
Hey Eddy,
can you share the files as pdf files? At A4 Site. So we can print it out?

Oh sorry, it looks very well!!! Well designed.
Only one question, why are you showing 7 Pins connectors for the motors?
Reply
#7
(06-09-2014, 12:17 AM)Sascha Wrote: Hey Eddy,
can you share the files as pdf files? At A4 Site. So we can print it out?

Oh sorry, it looks very well!!! Well designed.
Only one question, why are you showing 7 Pins connectors for the motors?

Hi Sascha

I need 7 or 8 pin connector mic jack, 4 for stepper motors and 3 connections to Limit Switch on camera slider construction.

only requires 7 pin mic cable to the motor and limit switch that I put on the slider rails.

if not use a 7 pin, you can use a 4 pin mic jack connector.

regards,
ed

(06-02-2014, 12:01 PM)Airic Lenz Wrote: Nice work Ed!

Can you share the design files so that everyone can order its case? If there is a problem attaching your files, I can fix that - just let me know!

Thank you!

Hi Airic

I again tried to fix the Minie 2 acrylic box with construction "puzzle" with laser cutting and using a commercially available kompenen in my country.

There was some improvement in the bottom of the box to the hole DIP switches, motors BED ajust and also the PCB hole spacers.

Maybe not so perfect. I dross happy if you can fix it and can be used by all who are on this forum.

Original files in any format AE I sent to your email.

regards,
ed


Attached Files Thumbnail(s)
           
Reply
#8
hi Airic

Do you have another email I can send to the file size.

I have a problem to send it through this forum.

regards,
ed
Reply
#9
(06-10-2014, 07:50 PM)eddyhasby2014 Wrote: hi Airic

Do you have another email I can send to the file size.

I have a problem to send it through this forum.

regards,
ed


Wow - great work and a nice documentation!
I just sent you the mail.

Thanks,
Airic
Reply
#10
Hi Ed,

really nice job with the box. But I have a question. How did you realize the connection between the power connection of the board and the power connection of the box? With an power cable or just with some wires? And how did you integrat the on/ off switch? Maybe you have some pictures, that would be great Smile

Thanks
Chris
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)