Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Battery Indicator
#5
(03-23-2014, 06:57 PM)Airic Lenz Wrote: Did you adjust the motor current on the BEDs? To much current might be the problem.

Thanks Airic, I did adjust the current on the BED from the default 3.01K down to 2.70K. At the point it reads 2.70K the motor stops doing its back-n-forth movement all together and does not move at all.

However, the battery lead cable I made was coiled up (as you can see in the video). So I uncoiled the cable and the motor began to move counter clockwise in intervals as it should. It was moving a bit jerky though. Then I began to adjust the current to fine tune it, but then then motor went back to its back-n-forth dance.

I also noticed the BED gets really hot. Is that something I should worry about?
Reply


Messages In This Thread
Battery Indicator - sirminder - 03-22-2014, 01:58 PM
RE: Battery Indicator - Airic Lenz - 03-22-2014, 07:28 PM
RE: Battery Indicator - sirminder - 03-23-2014, 10:00 AM
RE: Battery Indicator - Airic Lenz - 03-23-2014, 06:57 PM
RE: Battery Indicator - sirminder - 03-23-2014, 09:37 PM
RE: Battery Indicator - Airic Lenz - 03-24-2014, 11:22 AM
RE: Battery Indicator - sirminder - 03-25-2014, 02:13 PM
RE: Battery Indicator - Airic Lenz - 03-25-2014, 02:25 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)