Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
White screen
#1
I am writing here to possibly get help with my miniEngine2.
I have soldered the PCB as instructed and I finally got my DUE to get it up and running.
Uploaded the program to the DUE without any issues, but when I plug in the power-supply (9VDC / 2A) in the PCB I just get a white screen on my ITEAD TFT.

The screen "powers" after some seconds, but activates again when I press either of the buttons or turn the rotary button.

Attached are images of my PCB that might help identify the problem.

In advance, thanks!

[Image: 1.jpeg]
[Image: 2.jpeg]
[Image: 3.jpeg]
[Image: 4.jpeg]
Reply
#2
First question: did you set the display to 16 bit? There is a small switch where you can do that.
Reply
#3
(03-17-2014, 05:35 PM)Airic Lenz Wrote: First question: did you set the display to 16 bit? There is a small switch where you can do that.

I just tried that, nothing happened :/

Don't know what to say, but suddenly it just started working :o

I will post back if any other issues occur!
Reply
#4
(03-17-2014, 05:37 PM)Marius Wrote: Don't know what to say, but suddenly it just started working :o

Big Grin
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)