Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rotary knob
#1
Dear Airic,

do you have advice for a nice and well fitting knob for the encoder. Perhaps from farnell.com?

Thanks
Sascha
Reply
#2
(03-14-2014, 07:12 PM)Sascha Wrote: Dear Airic,

do you have advice for a nice and well fitting knob for the encoder. Perhaps from farnell.com?

Thanks
Sascha

Not sure if you saw this, but the 3D printable box worked for me. http://www.thingiverse.com/thing:241814
Reply
#3
Didn't saw it before, where can I buy it Wink
Reply
#4
(03-14-2014, 07:12 PM)Sascha Wrote: ...do you have advice for a nice and well fitting knob for the encoder. Perhaps from farnell.com?

Hello Sascha,

any knob that is designed for 6mm shafts should work pretty fine. You should find plenty of them here (German shop) if you filter for 6mm shafts:

http://www.reichelt.de/Potiknoepfe/2/index.html?&ACTION=2&LA=3&GROUPID=3139

Cheers,
Airic
Reply
#5
Hey Airic,
I own this one : http://www.reichelt.de/Potiknoepfe/KNOPF-15-SW/3/index.html?&ACTION=3&LA=2&ARTICLE=9443&GROUPID=3139&artnr=KNOPF+15+SW
But the height is not "nice". The link you gave me, all the knobs have only a height of max 16mm. So I think i have to be ok with the one i have.
Thanks for that.

Cheers,
Sascha
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)